Click your trailer type below
ROLLER
Boat-Load-Mate™ is to be installed at the rear of the trailer, on the frame, where the transom of the boat rests.
Install Boat-Load-Mate™ while the boat is on the trailer to ensure proper placement.
Step 1
Place the Boat Load Mate in the correct position
9/16” Gap between the transom of the boat and the Boat Load Mate LATCH
1/16” Gap from the bottom of the boat and the Boat Load Mate BASE.
Step 2
Use a 3/16 drill bit to drill pilot holes.
Step 3
Use the provided bolts and a 9/16 socket wrench to fasten the bolts
*DO NOT OVER TIGHTEN THE BOLTS
BUNK
Boat-Load-Mate™ is to be installed at the end of the trailer on the bunk rail near the boat's transom.
Install Boat-Load-Mate™ while the boat is on the trailer to ensure proper placement.
Step 1
Place the Boat-Load-Mate™ in the correct position
9/16” Gap between the transom of the boat and the Boat Load Mate LATCH
1/16” Gap from the bottom of the boat and the Boat Load Mate BASE.
Step 2
Use a 3/16” drill bit to drill pilot holes into the bunk.
Step 3
Use the provided hardware kit 9/16 socket and to fasten Boat-Load-Mate to the bunks.
*DO NOT OVER TIGHTEN THE BOLTS